Installing Reservoir Staff Gages

How is a staff gage installed in a reservoir?  The typical way is to drive a piece of 2″ galvanized pipe into the ground, deep enough to so it isn’t easy to push over.  If cattle will be in the reservoir to get water, then the pipe needs to be really well installed.  A gas-powered post pounder can be rented at Rental Guys, Home Depot, or similar places.

Most reservoirs are deeper than six feet, so it’s best to maximize the length of pipe installed.  The length of pipe that can be installed by hand is usually about 6 feet.  For a 6-foot tall pipe, about 3 feet of pipe needs to be in the ground, so the total pipe length is 9 feet.

Then the staff gage is attached to a 2″ x 8″, using screws or small bolts.  Staff gages vary in width from 1″ to 4″; the usual USGS Style C staff gages are 2-1/2″ wide.  Once the staff gage is screwed on, the board is U-bolted to the pipe.

That’s it…except for the surveying part.  The top of staff gage needs to be at the same level as the spillway crest, so the maximum water surface elevation can be measured.

If the reservoir is deeper than 6 feet, and most are, then staged staff gages may be needed.  The first gage is installed at the top, going from, say, 6 feet to 12 feet.  The second, lower staff gage is installed from 0 feet to 6 feet, and 6 feet is exactly the same elevation on both staff gages.  In the photo below, there are 3 staged staff gages to measure 18 feet in elevation.  The top of the third, lowest staff gage can be seen in the bottom right corner.

What if a pond is full, or mostly full?  It is still possible to install a staff gage, but it will be harder.  Boats or rafts will be needed, and the pipe with the board already attached has to be put in place and held vertical while being driven.  If the total depth is greater than 6 feet, then a longer pipe, board, and staff gage will be needed, and the combined weight will be that much greater.  Hint: tie a rope and buoy to the pipe so when if it slips and sinks, it can be pulled up again.

What about installing a staff gage along the slope of a dam, to avoid having to wrestle a pipe and board for a deep installation?  This can be done by attaching a length of rebar or pipe to the dam face using concrete stakes or similar method.  The slope distances measured are converted to vertical depths.  However, this won’t stand up well to cattle or elk traffic, and it is more liable to be vandalized if the reservoir has easy access.

Advertisements

Published by

AllWaterRights - Rights To Water Engineering

Solving Diverters' Headaches To Provide Peace Of Mind And Help Stay Out Of Trouble. Helping California residents understand, define, and protect their water rights since 2005.

Thanks for visiting All Water Rights! Please leave a comment. Questions? Contact Rights To Water Engineering, (530) 526-0134

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s